A machined plastic part is rarely expensive because of the material alone. It is expensive because of how it is designed: how much of the drawing is toleranced, how thin the walls are, whether the part can be held while it is cut. These eight rules come from real jobs and they cost nothing to apply.
1. Tolerance only what functions
The single biggest cost driver is a blanket tolerance. A part toleranced ±0.01 mm everywhere has to be re-worked, measured and often scrapped, while the same part toleranced ±0.01 mm on two critical faces and ±0.1 mm elsewhere machines in one pass.
Mark the datum and the critical dimensions, and leave the rest open.
2. One clear datum, not twenty
Inspection is only as good as the reference. Plastics move with temperature and clamping force, so a drawing with several competing datums forces repeated re-setup. Choose the face or bore that the part is installed against and dimension from it.
3. Keep walls thick enough to hold
Thin plastic walls deflect under tool pressure and vibrate, which ruins both size and finish. As a working guide, keep walls at 1 mm minimum on PEEK and POM, and 1.5–2 mm on softer grades such as PTFE and LDPE. Where a thin section is functionally necessary, say so on the drawing so we can plan a support fixture.
4. Break sharp internal corners
A square internal corner concentrates stress and always ends up with a tool radius anyway. Specify the radius you want (typically 0.4–1 mm) rather than leaving it to the machinist, because the radius follows from the cutter and the drawing should agree with reality.
5. Design press fits for plastic, not for steel
Plastics are stiffer in compression than they look. A press fit above roughly 0.1–0.2% of diameter on POM, and much less on glass-filled grades, will crack the part or leave it over-stressed. Use a light interference with a lead-in chamfer, or switch to a retaining method that does not rely on hoop stress.
6. Decide the moisture condition before you dimension
Nylon absorbs moisture from the air and grows; POM, PTFE and PEEK barely move. On nylon bushings and gears, dimensions measured dry are not the dimensions in service. Either state the fitted moisture condition, or specify a material that does not move.
7. Let the material do the sealing or sliding
A PTFE or rubber component usually seals better with less precision than the same part in POM. Rather than tightening a dimension that is hard to hold, consider whether a softer material or a compliant feature can absorb the variation.
8. Send a 3D model if you have one
A 3D step file lets us verify features and detect a contradiction between the model and the 2D dimensions before cutting metal — which is much cheaper than discovering it on the machine. The 2D drawing still governs the toleranced dimensions.
What we need to quote accurately
- 2D drawing with the datum, tolerances and material grade
- 3D model if available
- Operating temperature, the medium the part touches, and the load
- Quantity and required date
That is enough for most quotes within 24–48 hours. See the process guide for what we can hold on each material, or send the drawing directly.