Non-metallic parts are not machined like steel, and the differences are the ones that decide whether a part comes off the machine on size or comes off looking like it.
What we run
- CNC Turning — bushings, sleeves, rollers, rings, valve seats, insulators. Bars, tubes, near-net rod.
- CNC Milling — plates, brackets, manifolds, gear blanks, pockets, complex 3D profiles.
- Swiss Machining and 5-Axis Machining — small-diameter long parts and parts with features on several faces.
- Surface Finishing — as-machined, polished, bead-blasted and deburred finishes.
- Laser Cutting and Tube & Pipe Fabrication — sheet, plate and tube cut to blank size before machining.
Every capability page carries its own parameter table, typical applications and a real job example.
The four things that decide tolerance
- Material stiffness and thermal expansion. Plastics move roughly ten times more than steel per degree. A part checked hot in the machine will be wrong cold.
- Moisture uptake. Nylon grows with humidity; POM and PTFE barely move. On nylon, dimensions must be specified at a stated moisture content.
- Clamping and cutting heat. Soft materials deflect under clamping and smear when the chip is re-cut. Air blast, sharp positive-rake tooling and light finishing passes are standard practice here.
- Feature geometry. Thin walls, long unsupported bores and sharp internal corners are where tolerance gets expensive.
As a rule of thumb, ±0.05 mm is comfortable on most plastics and ±0.01 mm is achievable on POM, PEEK and PTFE with the right fixturing and temperature control. Ceramics and graphite hold tolerance after sintering or grinding, so their process flow is different again.
Design notes that save money
- Specify tolerance only on the features that function; open up everything else.
- Allow a generous corner radius instead of a sharp internal corner.
- Avoid press fits on stiff plastics (POM) above about 0.1–0.2% of diameter; use a light interference with a lead-in chamfer instead.
- For nylon, either accept moisture movement or specify the fitted condition.
- On ceramics, design for the as-fired shrinkage and grind only the sealing or sliding faces.
- Mark the datum and the critical dimensions on the drawing — one clear datum is worth more than twenty tight tolerances.